Gerard Rubio

Founder of Kniterate

  • Total activity 148
  • Last activity
  • Member since
  • Following 0 users
  • Followed by 0 users
  • Votes 2
  • Subscriptions 64

Activity overview

Latest activity by Gerard Rubio
  • Gerard Rubio commented,

    Thank you for all those pictures Lula. The tip of the feeders look ok. I would adjust feeder one a bit, though, to be more like this, in red below. A bit more towards the rear bed.Are your brushes ...

  • Gerard Rubio commented,

    Hi Lula, could you share a few pictures of your feeders close to the needle bed to see their exact position? Could you also share a picture of the top part of the feeder, the part attached to the r...

  • Gerard Rubio created an article,

    "Waiting for carriage connection" message

    This message is displayed when the mainboard underneath the machine can't connect with the board in the carriage. Please check this article first to see if the clump sensors are causing this. If s...

  • Gerard Rubio commented,

    Hi Amy, YarnT stands for Yarn Top, which are the top yarn control units. Do you see any red lights up there? We have some information about errors on page 46 of the instructions manual and in the o...

  • Gerard Rubio commented,

    Hi Jason, that link is outdated. The one that has the updated timeline was shared previously. I'll send it again privately. Thank you.

  • Gerard Rubio commented,

    Hi Patricia, Could you recheck the link? We keep the list with all the orders hidden as it contains confidential customer information. Thank you

  • Gerard Rubio created a post,

    Update #49: Jan-Mar 2023 Update

  • Gerard Rubio commented,

    Hey Dorin, it seems the stitch is a bit too tight - the yarn might be too thick for the default stitch size the file has. Please try increasing by 1 or 2 points the stitch size across the entire fi...

  • Gerard Rubio commented,

    Hi Christine, I ran the warm-up file on a machine of ours, and I found the same issue. I edited the kcode a bit, so the feeders are spaced out better: carriers 3 and 4 are fully overlapped now, lea...

  • Gerard Rubio commented,

    Hi Kyle, we will start working on something like that soon at Kniterate! So users can share designs and load them directly into the app. Please reach out at info @ kniterate . com if you are intere...